Roland SP-404MK2 Reference Manual page 79

Controller
[CTRL 2] knob (when the
loop is on)
[CTRL 3] knob
[SHIFT] button + [CTRL]
knob (turn)
[VALUE] knob (turn)
[VALUE] knob (press)
[SHIFT] button + [VALUE]
knob (turn)
[DEL] button
[REMAIN] button
[ROLL] button
Playing back a pattern
You can play back the patterns that you created in DJ mode.
1. Press the [PATTERN SELECT] button.
2. Press pads [1]–[16] to select a pattern to play back.
3. Press the [PATTERN SELECT] button.
4. Press the [PATTERN EDIT] button.
The [PATTERN EDIT] button blinks, and the pattern playing back screen appears.
5. Press pad [13].
This plays back the pattern.
Use the [CTRL 1]–[CTRL 3] knobs and press pads [1]–[16] to mix the sound, as with the samples.
Moves the loop point.
Moves the end point.
Zooms the area around each point in/out.
Zooms the area in/out around each point you just manipulated.
You can use a numerical value to set the position of each point.
Use the [VALUE] knob to select the point to set, and press pads [1]–[10] to input the
position (press pad [10] to input a "0").
To confirm the inputted position, press the [VALUE] knob.
Adjusts the volume of the channel.
Initializes the start and end point positions.
●
When a confirmation message appears, use the [VALUE] knob to select "OK", and
press the [VALUE] knob.
On: Prevents the start point from being moved beyond the loop point or the end point.
Off: When the start point moves beyond the loop point or the end point, this moves the
loop point or the end point as well.
While this button is pressed, you can preview the sound several seconds before the end
point.
Mixing the Samples (DJ MODE)
Action
79