Table of Contents
Advertisement
CANFDNET-400U
High-performance Four-channel CANFD Bus-to-Ethernet Converter User Manual
After the converter enters the configuration
the software; otherwise, the software will consider the converter not connected. After
setting the configuration parameters, click Write Configuration to write the parameters to
the device for curing. The following describes the main configuration parameters in detail
with reference to the configuration software.
3.2.1
Conversion Parameters
Conversion parameters refer to parameters such as the conversion rule direction of
the converter. Figure 3.2 shows the conversion parameter interface.
Conversion mode: includes four selectable conversion modes: transparent
conversion, transparent conversion with flags, format conversion, and Modbus mode.
Conversion direction:
Bidirectional: The converter converts the data of the serial bus to the CAN bus, and
also converts the data of the CAN bus to the serial bus.
Only serial port to CAN: Only convert the data of the serial bus to the CAN bus,
without converting the data of the CAN bus to the serial bus.
Only CAN to serial port: Only convert the data of the CAN bus to the serial bus,
without converting the data of the serial bus to the CAN bus.
[Note]: By selecting the conversion direction, the data interference on the bus side
that does not need conversion can be eliminated.
Allow CAN frame information to be forwarded into serial frames:
This parameter is
is selected, the converter will add the frame information of the CAN (CANFD) message to
the first byte of the serial frame when it is working. When this parameter is not selected,
Figure 3.2 Configuration software interface
only used in "transparent conversion"
©2021 Guangzhou ZLG Microelectronics Technology Corp.,Ltd.
9
mode, the parameters can be set by using
mode. When this parameter
User Manual
Advertisement
Table of Contents
