Choosing Ids - FujiFilm FP-Z6000 Manual

IDs let you operate multiple projectors, either separately or together, using a single remote
control. This example sets the ID to "02".
1 Check the projector and remote control IDs.
Display the IDs by pressing the ID SET button on the remote control.
2 Set the projector ID.
The projector ID defaults to "off ".
Select Projector ID Setting in the SYSTEM SETUP: Basic menu.
A
Select On for Projector ID Setting in the ID selection display. Next, select "02" and
B
press ENTER.
3 Set the remote control ID.
The remote control ID defaults to 01.
control: Press and hold ID SET on the remote control
A
Remote
for three seconds.
→ The remote control operation lamp will start to fl ash.
Press "0" "2" on the 10-key pad.
B
Press ENTER.
C
→ The remote control operation lamp will stop fl ashing.
Once the operation is complete, check that the IDs on the projector and
4
CAUTION
remote control are correct.
Projectors with IDs off can be controlled by remotes with any ID between "01"
b
TIP
and "99".

Choosing IDs

EN-30