Precautions For Storage And Use - FujiFilm FP-Z6000 Manual

Safety Precautions
• Keep safety in mind when stringing cables. Failure to observe this precaution could result
in falls or injury.
• Do not install the product in locations subject to shock or vibration.
• Do not touch the lens immediately after switching the product to standby. Failure to
observe this precaution could result in burns.
• Be sure the product is properly grounded.
• The plastic bags provided with this product present a suff ocation risk when placed over
the nose and mouth. Store them out of reach of infants and young children.

Precautions for Storage and Use

Precautions for Storage and Use
• Do not use or store the product in locations subject to extreme temperatures. Avoid
locations that are subject to sudden changes in temperature. Operate and store the
product within its operating and storage temperature limits.
• Do not install the product in the vicinity of high-voltage power lines or equipment that
produces magnetic fi elds. The product may not function as expected.
• Do not use the product when it is tilted. Failure to observe this precaution could damage
the product or cause accidents.
• Do not touch the lens with your bare hands. Fingerprints and smudges on the lens can
aff ect picture quality. To keep the lens clean and free of scratches, replace the lens cap
when the product is not in use.
• Remove the batteries from the remote control before placing it in storage. Leaving the
batteries in place for long periods could result in leakage or other damage to the batteries.
• Do not use or store the product where it will be exposed to soot or tobacco smoke. Failure
to observe this precaution could result in reduced picture quality.
• Malfunction or damage due to such causes as fi re, earthquakes, fl oods, lightning, or other
acts of God; man-made pollution or environmental disasters; salt; voltage fl uctuations; or
use of power sources operating at unauthorized voltages or frequencies is not covered
under warranty.
• To clean the lens, fi rst switch the product to standby and wait for the lens and metal parts
to cool, then remove dust and lint with a blower before gently wiping the lens with a
third-party glass-cleaning cloth or the like.
• Allow the lens to cool before performing cleaning.
• When transporting the product, hold it by its base. Do not hold it by the lens or the
opening around the lens. Failure to observe this precaution could damage the product.
• Thread-locking adhesive, lubricants, or grease on the ceiling mounts could cause the
projector's plastic casing to deteriorate, potentially damaging the product or causing it
to fall.
• Do not install or store the product where it will be exposed to salt damage or corrosive
gases. Corrosion could damage the product or cause it to fall.
EN-4