Cautions - FujiFilm FP-Z6000 Manual

Safety Precautions
• Do not insert fl ammable material, metal, or other foreign objects into the product or leave
them in its vicinity. Failure to observe this precaution could result in fi re, burns, or electric
shock.
• Do not use sprays containing fl ammable gas to remove dust or other foreign matter from
the lens. The gas could ignite, causing fi re.
• Do not use the product in locations where the air may contain fl ammable or explosive
gases. The gases could ignite, causing fi re.
• Do not place fl ammable objects in front of the lens. Failure to observe this precaution
could result in fi re.
• This apparatus must be grounded.
• Do not block the light from the product with books, cloths, or other objects. Objects
placed in the beam could become hot, potentially melting or causing burns or fi re.
Light refl ected from the objects could also cause the lens to overheat, causing product
malfunction.
• Do not touch the lens or metal parts of the product while it is on or immediately after it
has been switched to standby. Failure to observe this precaution could result in burns or
other injury.
• Be careful not to drop the product when lifting it.
• Should you notice that the product is not functioning normally, switch it to standby and
disconnect the power and USB cables. Continuing to use the product when it is emitting
smoke or unusual smells or otherwise functioning abnormally could result in fi re, electric
shock, or visual impairment.
• Use only the supplied power cable. Using other cables could cause overheating or an
electrical short leading to fi re or electric shock. Failure to properly ground the outlet to
which the supplied power cable is connected could also result in electric shock.
4 4

CAUTIONS

CAUTIONS
• Use the product only as described in this manual.
• The product and its accessories are precision devices. Under no circumstances should
they be subjected to excessive force.
• Replace the lens cap if the product will not be used for an extended period.
• The lens includes moving parts: do not apply excessive force or subject the lens to physical
shocks.
• Do not install this product in locations that are dusty, humid, or exposed to soot, steam,
or sources of heat. Failure to observe this precaution could result in fi re or electric shock.
In addition, grease could cause the projector's plastic casing to deteriorate, damaging the
supports and potentially causing the product to fall.
• Do not leave the product in locations where it will be exposed to high temperatures or
direct sunlight. Failure to observe this precaution could result in fi re.
EN-2