Optional Floor Kit Mounting - ABB ACQ580-P Series Installation Manual

The ACQ580 irrigation drive package is factory programmed in the following parameters:
Parameter Parameter name
12.25 AI2 unit selection
19.11 Ext1/Ext2 selection
20.01 Ext1 commands
20.04 Ext1 in2 source
20.06 Ext2 commands
20.08 Ext2 in 1 source
20.09 Ext2 in 2 source
20.21 Direction
20.41 Start interlock 1
21.03 Stop mode
28.11 Ext1 frequency ref1
28.15 Ext2 frequency ref1
Constant frequency
28.22
sel1

Optional floor kit mounting

Optional floor/ground mounting kits are available for purchase. Assembly instructions for the
floor kits are shipped with each kit and should be used for installation. Abbreviated versions of
the instructions can also be found as a reference below.
WARNING! Before you begin read
WARNING! When the ACQ580 irrigation drive package is connected to the line power, the
Motor Terminals T1, T2, and T3 are live even if the motor is not running. Do not make any
connections when the ACQ580 irrigation drive package is connected to the line.
Disconnect and lock out power to the drive before servicing the drive. Failure to disconnect
power may cause serious injury or death.
Value
mA
DI3
In1 Start, In2 Dir
DI2
In1 Start, In2 Dir
DI6
DI5
Request
DI4
Coast
AI1 scaled default (if +G303 speed pot. is included)
OR
Control panel; ref saved (if no +G303 speed pot. is included)
AI2 scaled
Always off
Safety instructions on Page 2 .
21