hca_self_test Utility
Host Driver Initialization ............. PASS
Number of HCA Ports Active ............. 2
Port State of Port #0 on HCA #0 ........ UP 4X
Port State of Port #1 on HCA #0 ........ UP 4X
Error Counter Check on HCA #0 .......... PASS
Kernel Syslog Check .................... PASS
Node GUID .............................. 00:05:ad:00:00:20:08:48
------------------ DONE ---------------------
Table 8-1
Table 8-1
Field
Number of HCAs Detected Number of HCAs on the host that the test recognizes.
PCI Device Check
Kernel Architecture
Host Driver Version
Host Driver RPM Check
HCA Type of HCA #0
HCA Firmware on HCA #0 Firmware version that runs on the HCA.
HCA Firmware Check on
HCA #0
Host Driver Initialization
Number of HCA Ports
Active
Port State of Port #0 on
HCA #0
Port State of Port #1 on
HCA #0
Error Counter Check
Kernel Syslog Check
Node GUID
Cisco SFS InfiniBand Host Drivers User Guide for Linux
8-2
lists and describes the fields in the hca_self_test output.
Fields in hca_self_test Output
Description
Confirms that HCA shows up correctly as a PCI device.
Kernel architecture on the host.
Version of the drivers on the host.
Confirms that the RPMs that are installed are compatible with the host
operating system.
Displays the HCA card type.
Displays PASS or FAIL.
Confirms that the IPoIB driver is installed correctly.
Number of enabled ports on the HCA.
Displays up or down to reflect the status of the port.
Displays up or down to reflect the status of the port.
Displays PASS or FAIL.
Displays PASS or FAIL.
IB node GUID.
Chapter 8
HCA Utilities and Diagnostics
OL-12309-01