Introduction - Cisco GEM318P User Manual

Host drivers for linux
Table of Contents

Advertisement

HCA Utilities and Diagnostics
This chapter describes the HCA utilities and diagnostics and includes the following sections:

Introduction

The sections in this chapter discuss HCA utilities and diagnostics. These features address basic usability
and provide starting points for troubleshooting.
See the
Note
significance of prompts used in the examples in this chapter.
hca_self_test Utility
This section describes the hca_self_test utility. The hca_self_test utility displays basic HCA attributes
and provides introductory troubleshooting information. To run this utility, perform the following steps:
Step 1
Log in to your host.
Step 2
Run the hca_self_test command.
The following example shows how to run the hca_self_test command:
host1# /usr/local/topspin/sbin/hca_self_test
rhel4-2.6.9-42.ELsmp-3.2.0-136
---- Performing InfiniBand HCA Self Test ----
Number of HCAs Detected ................ 1
PCI Device Check ....................... PASS
Kernel Arch ............................ x86_64
Host Driver Version .................... rhel4-2.6.9-34.ELsmp-3.2.0-136
Host Driver RPM Check .................. PASS
HCA Type of HCA #0 ..................... LionMini
HCA Firmware on HCA #0 ................. v5.2.000 build 3.2.0.136 HCA.LionMini.A0
HCA Firmware Check on HCA #0 ........... PASS
OL-12309-01
Introduction, page 8-1
hca_self_test Utility, page 8-1
tvflash Utility, page 8-3
Diagnostics, page 8-5
"Root and Non-root Conventions in Examples" section on page ix
C H A P T E R
Cisco SFS InfiniBand Host Drivers User Guide for Linux
8
for details about the
8-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

St373307lcSfs infiniband

Table of Contents