Table of Contents
Advertisement
8.
Release the ZIF connector (8) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the system board.
9.
Remove the nine Phillips M2.0 × 3.4 screws (1) that secure the system board to the computer.
10.
Remove the Phillips M2.0 × 4.1 screw (2) that secures the system board to the computer.
11.
Release the solid-state drive housing (1) from molding that is built into the top cover/keyboard.
12.
Lift the left side of the system board (2) until it rests at an angle.
13.
Release the heat sink (3) from the rear edge of the top cover/keyboard.
14.
Release the audio jack (4) from the opening in the top cover/keyboard.
58
Chapter 5 Removal and replacement procedures for authorized service provider parts
Advertisement
Table of Contents
