Table of Contents
Advertisement
5.
Pull the solid-state drive (2) away from the socket to remove it.
To install the solid-state drive, reverse the removal procedures.
NOTE:
Solid-state drives are designed with a notch to prevent incorrect insertion.
Memory modules
To remove the memory modules, use this procedure and illustration.
Table 5-4
Memory module descriptions and part numbers
Description
8 GB memory module (SODIMM, DDR4-3200, 1.2v)
4 GB memory module (SODIMM, DDR4-3200, 1.2v)
Memory module shield: The memory module shield is not available as a spare part component.
Before removing the memory, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
If you are replacing a memory module, remove the existing memory module:
1.
Use the tab (1) and slot on the front of the memory module shield to lift and remove the shield (2).
The memory module shield is not available as a spare part component.
NOTE:
When installing the memory module shield, be sure that the edges of the shield fit into all the
retention clips (3) that are built into the system board.
Preparation for disassembly on page
Bottom cover on page
34).
34).
Battery on page
36).
Spare part number
L46598-005
L83673-005
Memory modules
39
Advertisement
Table of Contents
