To install a main memory module:
1 Disconnect the computer's power supply cord and any connection to
a telecommunication network.
2 Remove the computer's cover (described on page 9).
3 Remove the front chassis and place it upside down on the rear of the
Net PC (described in the section "Removing the Front Chassis", on
page 12). It is not necessary to disconnect any cables.
4 If you need to remove a main memory module, open the two tabs and
remove the module.
5 Align the notches in the memory module with the socket. Slide the
memory module into the slot at 90° to the system board. Close the
two tabs.
6 Replace the front chassis, ensuring that all cables are properly
routed as you slide it carefully into place.
7 Replace the two screws to secure the front chassis.
8 Replace the cover (described on page 10) and reconnect all cables
and power cords.
Accessories Guide
Installing Memory
English
15