FALCON RIDGE Club Car 1550 Instructions For Installation And Care

Mini cab enclosure with lexan windshield

Download this manual

Club Car 1550 Mini Cab Enclosure with Lexan Windshield

Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.

Be sure to read these instructions thoroughly before opening and installing. The installation is best done

when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if conditions

prevent installing in warmer weather it helps to store the adhesive Velcro at room temperature prior to

installation.

1. Carefully open the carton and remove the rolled up Cab Enclosure on a large flat surface that is clean

and free of dirt or other material that may soil or scratch the windows of the Cab.

2. It will help to unhook the hood prior to installing the cab enclosure

3. Check over the parts included in the carton with the parts list shown below:

Velcro Hook strips:

Cab Enclosure

If any parts are damaged or missing please contact customer service at (606) 845-7439.

4. Begin by installing the windshield as described in the instruction included with it. After installing the

windshield drape the enclosure over the top of the vehicle and center it on the roll cage.

5. Next raise the bed and place the 32" adhesive Velcro strip across the bottom rear of the cab, align with

Velcro on rear of cab. Now pull down on the rear of the cab enclosure and affix to the Velcro. See

Photo at top of next page:

2515 Bypass Rd. Flemingsburg, KY 41041

606-845-7439

Instructions for Installation and Care of

CC-1550-MC02

3" long

4 each

8" long

4 each

10" long

2 each

32" long

1 each

48" long

1 each

Page 1 2515 Bypass Rd. Flemingsburg, KY 41041 606-845-7439 Instructions for Installation and Care of Club Car 1550 Mini Cab Enclosure with Lexan Windshield CC-1550-MC02 Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
Page 2 Cab to either extreme hot or cold temperatures when storing. 3. A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.
Page 3 Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory new condition.

Cc-1550-mc02