Esp/Bas Malfunction Indicator Light And Esp/Tcs Indicator Light - Chrysler PT Cruiser 2008 Owner's Manual

Indicator Light should go out. However, if the light
remains on, have the ESP and BAS checked at your
authorized dealer as soon as possible.
ESP/BAS Malfunction Indicator Light and
ESP/TCS Indicator Light
The Malfunction Indicator Light for the ESP is
combined with the BAS indicator. The yellow
"ESP/BAS Malfunction Indicator Light" and
the yellow "ESP/TCS Indicator Light" in the
instrument cluster both come on when the ignition
switch is turned to the ON position. They should go out
with the engine running.
The system will turn the "ESP/BAS Malfunction Indica-
tor Light" on continuously while the engine running if it
detects a malfunction in either the ESP or the BAS or
both. If the light remains on after several ignition cycles
and you have driven the vehicle several miles (kilome-
ters) at speeds greater than 30 mph (48 km/h), and the
ESP is synchronized (refer to Synchronizing ESP), see
your authorized dealer as soon as possible to have the
problem diagnosed and corrected.
NOTE:
• The ESP/TCS Indicator Light and the ESP/BAS
Malfunction Indicator Light will turn on momentarily
each time the ignition switch is turned ON.
• Each time the ignition is turned ON, the ESP System
will be on even if it was turned off previously.
• The ESP Control System will make buzzing or clicking
sounds when it is active. This is normal; the sounds
will stop when ESP becomes inactive following the
maneuver that caused the ESP activation.
STARTING AND OPERATING 327
5