Customer Sentry Key (Fob) Programming - Chrysler PT Cruiser 2008 Owner's Manual

procedure. This procedure consists of programming a
blank fob to the vehicle electronics. A blank fob is one
that has never been programmed.
NOTE: When having the Sentry Key
System serviced, bring all vehicle fobs with you to the
authorized dealer.

Customer Sentry Key (Fob) Programming

If you have two valid Sentry Keys , you can program
new Sentry Keys to the system by performing the
following steps:
1. Insert the first valid key into the ignition switch and
turn the ignition switch to the ON position for at least
three seconds, but no longer than 15 seconds. Turn the
ignition switch to the OFF position and remove the first
key.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17
2. Insert the second valid key and turn the ignition
switch to the ON position within 15 seconds. After 10
seconds, a chime will sound and the Vehicle Security
Alarm Indicator Light will begin to flash. Turn the
Immobilizer
ignition switch OFF and remove the second key.
3. Insert a blank Sentry Key into the ignition switch and
turn the ignition switch to the ON position within 60
seconds. After 10 seconds, a single chime will sound and
the Vehicle Security Alarm Indicator Light will stop
flashing, turn on again for three seconds, and then turn
off.
The new Sentry Key is programmed. The Keyless Entry
Transmitter will also be programmed during this pro-
cedure.
Repeat this procedure to program up to eight keys. If you
do not have a programmed Sentry Key , contact your
authorized dealer for details.
2