Synchronizing Esp; Esp/Bas Malfunction Indicator Light And Esp/Tcs Indicator Light - Chrysler 300 SRT8 2010 User Manual

Hide thumbs Also See for 300 SRT8 2010:
Table of Contents

Advertisement

WARNING!
With the ESP switched OFF, the enhanced vehicle
stability offered by ESP is unavailable. In an emer-
gency evasive maneuver, the ESP system will not
engage to assist in maintaining stability. The "Full
Off" ESP mode is intended for off-highway or off-
road only.

Synchronizing ESP

The Malfunction Indicator Light for the ESP is
combined with BAS indicator. If the power
supply is interrupted (battery disconnected or
discharged), the "ESP/BAS Malfunction Indi-
cator Light" may illuminate with the engine running. If
this should occur, turn the steering wheel completely to
the left and then to the right. The "ESP/BAS Malfunction
Indicator Light" should go out. However, if the light
remains on, have the ESP and BAS checked at your
authorized dealer as soon as possible.
ESP/BAS Malfunction Indicator Light and
ESP/TCS Indicator Light
The Malfunction Indicator Light for the ESP is
combined with the BAS indicator. The "ESP/
BAS Malfunction Indicator Light" and the
"ESP/TCS Indicator Light" in the instrument
cluster both come on when the ignition switch is turned
to the ON position. They should go out with the engine
running.
The system will turn the "ESP/BAS Malfunction Indica-
tor Light" on continuously while the engine is running if
it detects a malfunction in either the ESP or the BAS or
both. If the light remains on after several ignition cycles
and you have driven the vehicle several miles (kilome-
ters) at speeds greater than 30 mph (48 km/h), and the
STARTING AND OPERATING 293
5

Advertisement

Table of Contents
loading

Table of Contents