Synchronizing Esp; Esp/Bas Malfunction Indicator Light And Esp/Tcs Indicator Light - Chrysler 300 Owner's Manual

344 STARTING AND OPERATING
switch. Once the situation requiring "Partial Off" mode is
overcome, turn the ESP on again by momentarily press-
ing the ESP OFF switch. This may be done while the
vehicle is in motion.

Synchronizing ESP

The Malfunction Indicator Light for the ESP is
combined with BAS indicator. If the power
supply is interrupted (battery disconnected or
discharged), the "ESP/BAS Malfunction Indi-
cator Light" may illuminate with the engine running. If
this should occur, turn the steering wheel completely to
the left and then to the right. The "ESP/BAS Malfunction
Indicator Light" should go out. However, if the light
remains on, have the ESP and BAS checked at your
authorized dealer as soon as possible.
ESP/BAS Malfunction Indicator Light and
ESP/TCS Indicator Light
The Malfunction Indicator Light for the ESP is
combined with the BAS indicator. The "ESP/
BAS Malfunction Indicator Light" and the
"ESP/TCS Indicator Light" in the instrument
cluster both come on when the ignition switch is turned
to the ON position. They should go out with the engine
running.
The system will turn the "ESP/BAS Malfunction Indica-
tor Light" on continuously while the engine running if it
detects a malfunction in either the ESP or the BAS or
both. If the light remains on after several ignition switch
cycles, and you have driven the vehicle several miles
(kilometers) at speeds greater than 30 mph (48 km/h),
and the ESP is synchronized (refer to Synchronizing ESP),
see your authorized dealer as soon as possible to have the
problem diagnosed and corrected.