HP Kayak XA User Manual page 34

ashak.bk : ashak-2.fb4 Page 26 Wednesday, July 15, 1998 6:41 PM
Before Installing an
IDE Hard Disk
Before Installing a
SCSI Hard Disk
NOTE
2 How to Install Accessories Inside Your PC Workstation
Installing Mass Storage Devices
Refer to the drive's installation guide to see if you must set jumpers or if
there is a special installation procedure to follow.
If you are installing an additional SCSI drive, you should assign an
unused SCSI ID to this accessory. SCSI IDs range from 0 to 15 for Ultra
wide 16-bit SCSI. SCSI ID 0 is used by the first SCSI hard disk drive and
SCSI ID 7 is reserved for the integrated SCSI controller (the default for
narrow and wide SCSI devices).
You do not need to select a SCSI ID for Plug and Play SCSI hard disks
(SCSI hard disks that support the SCAM protocol).
You should assign an unused SCSI ID to the second SCSI hard disk
drive (for example, SCSI ID 1).
The SCSI ID is usually configured with jumpers on the SCSI hard disk
drive. Refer to the installation guide supplied with the drive for
information on selecting a SCSI ID.
Some internal SCSI disk drives may have termination resistors that
must be removed or disabled before installation in your computer.
Refer to the drive's installation guide for more details and to see if
there is a special installation procedure to follow.
26 English