Installing The Cooker - Miele H 2265-1 B Operating And Installation Instructions

Installing the cooker

For safety reasons, the cooker may
only be used when it has been fully
installed.
The cooker requires a sufficient sup-
ply of cool air for efficient operation.
The required supply of cool air must
not be excessively heated by other
heat sources (e.g. solid fuel stoves).
The following must be observed
when installing the appliance:
Make sure that the interim shelf that
the cooker sits on does not touch the
wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
Before installation
 Ensure that there is no power to the
socket.
 Please observe the wiring diagram on
the cooker.
 Remove the appliance lid to connect
the single conductors of the power
cable to the connection terminals.
All H 2xxx I cookers that are combined
with an induction hob are also
equipped with a ferrite ring.
With the exception of the earth con-
ductor, all other single conductors of
the power cable must be drawn
through the aperture of the ferrite ring
before they are secured to the con-
nection terminals.
 Secure the single conductors to the
respective connection terminals.
 Replace the appliance lid.
Installing the cooker
 Connect the cooker to the electrical
supply.
 Place the cooker in front of the base
unit.
 Insert the plug of the built-in hob into
the connection on the cooker.
Lifting the cooker by the door handle
could cause damage to the door.
Use the handle cut-outs on the side
of the housing to lift the appliance.
It is a good idea to remove the door
(see "Cleaning and care – Removing the
door") and to remove the accessories
before installing the appliance. The
cooker is then easier to push into the
cabinet carcase and you do not run the
risk of lifting it by the door handle.
 Push the cooker into the base unit
and align it.
 Open the door, if you have not re-
moved it.
 Secure the cooker to the side walls of
the cabinet carcase using the screws
supplied.
 Refit the door if necessary (see
"Cleaning and care" – "Fitting the
door").
Installation
73