Chrysler 2007 300 SRT8 Owner's Manual page 118

118 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
1. Press and hold the two outer HomeLink buttons.
Release the buttons only when the EVIC displays "Chan-
nels Cleared" (after 20 seconds); however, do not hold
the buttons for longer than 30 seconds. Do not repeat this
step if programming a second or third hand-held trans-
mitter to the remaining HomeLink buttons.
HomeLink Buttons
2. Position the end of your hand-held transmitter 1-3
inches (3-8 cm) away from the HomeLink buttons.
3. Simultaneously press and hold the HomeLink button
(that you want to train) and the hand-held transmitter
button. Do not release the buttons until Step 4 is
complete.
NOTE: Some gate operators and garage door openers
may require you to replace this Programming Step 3 with
procedures noted under Gate Operator/Canadian Pro-
gramming.
4. The EVIC will display "Channel X Training" (where X
is Channel 1, 2, or 3). Release both buttons after the EVIC
displays "Channel X Trained."
NOTE: If the EVIC displays "Did Not Train," repeat
Steps 2–4.
5. Press and hold the just trained HomeLink button and
observe the EVIC display. If the EVIC displays "Channel
X Transmit" (where X is Channel 1, 2, or 3), then
programming is complete, and your device should acti-
vate when the HomeLink button is pressed and released.
NOTE: To program the remaining two HomeLink but-
tons, begin with Programming Step 2. Do not repeat
Step 1.