Villager VWM 200 Combo Original Instruction Manual page 32

Villager
2.3.4 CONNECT THE EARTH CLAMP
●Connect the earth clamp firmly to the welding bench or the workpiece.
●To increase the quality of the welding, earth clamp on the work piece should be clamped
tightly and as close to the welding area as possible. For more detail please refer to the Welding
Parameter Selection table.
Do not place the earth clamp on the welding machine or the gas cylinder;
otherwise the welding current will be carried via the protective conductors and
it will destroy these.
Welding Current
for MMA
Connection of Gun and Welding cable on the front panel:
●Output (＋) or welding Gun connector: Connect to the Gun for MIG/MAG welding process.
●Output (－) or Black connector: Connect to the workpiece for MIG/MAG and MMA welding
process.
●Output (＋) or the Red connector: Connect to the Electrode holder for MMA
Power LED1
Welding Current
for MIG/MAG
Figure 1: The front panel of Welding power source
VWM 200 Combo (GB)
Over-heat LED2
Inductance for
MIG/MAG
Wire Inching for
MIG/MAG
MIG/MAG or MMA
Selection