Work Area - Villager VWM 200 Combo Original Instruction Manual

Villager VWM 200 Combo (GB)
•
User Manual

2.2 WORK AREA

●Make sure that your line voltage is 1 Phase, 230V~, 50 Hz for VWM 200 combo And you have
a neutral and earth line present at your work place.
●In order to cool down the machine and have an efficient work, keep the machine at least 30
cm away from the surrounding objects. Do not place any heat source, as oven, to front side of
the machine where the cooling air is taken from. Welding machine must not be effected of heat
directly.
●Do not place the machine in small and narrow places. Beware of excessive dust and dirt.
●Keep your machine away from wet and humid places.
●Do not operate the machine under direct sunlight, rain and wind. Machines should be
operated on lower capacities when ambient air temperature exceeds 40ºC.
●Please use a suitable exhaust system for gases and cutting vapours.
Use breathing apparatus if there is a risk of inhaling any welding or cutting vapours.
●Avoid welding where air-flow is high. Protect the welding area with curtains or mobile
screens.
●Transport and place the device on firm and level ground so that it may not fall over. The
maximum permissible angle of inclination for transport and assembly is 10°.
●If the cylinder is placed on the machine lock the chain to secure the tube, if not be sure that
gas cylinder is chained vertically to a wall.
●This machine is protected electronically against overloading. Do not use stronger fuses than
those stated on the type plate of the device.
●Ensure that the earth clamp has good and direct contact near the welding location. Do not
direct welding current over chains, ball bearings, steel cables, protection conductors etc.,
Otherwise they may melt.
●Ensure that operators can asily reach the machine controls and equipment connections.
●Use lifting eyes for lifting the machine. Do not lift the machine by using a fork-lift or a similar
vehicle.
●The electrical socket behind machine is only for heating CO2. Do not use it for any other
purpose.
2.3 INSTALLATION AND USAGE OF THE MACHINE
Only qualified persons should install, use or service this equipment. Protect yourself and
others from possible serious injury or death.
WARNING: Do not operate with covers removed.Disconnect input power before servicing.
Do not touch electically live parts.