Villager VWM 200 Combo Original Instruction Manual page 31

Villager
Electric shock can kill
●Have an electrician install and service this equipment
●Turn the input power off at the fuse box before working on equipment
●Do not touch electrically hot parts
●Before starting the installation,check with the power company to be sure your power supply
is adequate for the voltage,amperes,phase,and frequency specified on the welding machine
nameplate,Also be sure the planned installation will meet all local and national code
requirements.Some welding machines may be operated from a single phase line or from one
phase of a two or three phase line.
● Before connecting the input cable to the power supply,check that the power(on-off) switch
operates in the position corresponding to the input voltage that the machine will be connected
to.
CAUTION : If the power switch setting does not match the input power voltage,you may burn
up the welding machine!
●Connect the "PE" or green/yellow grounding wire in the input cord to a system ground per
the applicable national and local codes
2.3.1 CONNECT THE MACHINE TO POWER SUPPLY
● The connection to the main lines is made by the end user. It has to be performed by qualified
electricians or by the people trained in this area.
● Power supply cable to the machine must be connected to the main power supply switch.The
main power supply has been labeled in the nameplate of the machine, for example,
1～，50Hz，230 VAC.
● For VWM 200 combo
be used.
● Before turning on the main power supply switch user must check carefully these connections
of the power supply cable and earth cable (Yellow/Green) to the machine.
2.3.2 CONNECT THE ELECTRODE HOLDER FOR MMA
●Connect the Electrode holder to the Red connector (on the front panel) of the welding
machine for MMA. Be sure that connections are correct and not loose.
2.3.3 CONNECT THE EARTH WELDING CABLE TO THE MACHINE
●Connect the one end of the earth welding cable to the workpiece, and the other end should
be connected to Output (-) (Black connector on the front panel) of the welding machine.
(1～，50Hz，230 VAC), the 3G1.5 mm² power supply cable should
Be sure that connections are fastened tightly. Loose or incorrect
fastening may cause the connection to overheat or burn. Unespected
results may occure if a mistake is made in the network connection. Pay
attention that the connection of the earth cable (Yellow/Green) to PE
end of the machine.
VWM 200 Combo (GB)