Arc Welding Can Cause Interference - Villager VWM 200 Combo Original Instruction Manual

Villager VWM 200 Combo (GB)
FALLING UNIT CAN CAUSE INJURY
Wrong positioned power source or other equipment may cause serious injury to persons or
damage to objects.
●While repositioning the power source always carry by using the lifting eye. Never pull cable,
hose or Gun.
Always carry the gas cylinders separately.
●Before carrying the welding and cutting equipment, disassemble all the connections between
and separately carry the small ones by handgrips and the big ones by lifting eyes or by using
appropriate vehicles like forklifts.
●Install your machine on flat platforms having maximum 10° slope that it does not fall over.
Install it on well ventilated, non-confined places away from the dust, also avoiding the risk of
falling caused by cables and hoses. For gas cylinders not to fall over, attach it to the mobile
machine or to the wall with a chain.
●Ensure that operators easily reach the controls and connections on the machine.
MAINTENANCE MADE BY UNQUALIFIED PERSONS MAY CAUSE INJURIES
●Electrical devices should not be repaired by unqualified persons. Improper repairs can cause
serious injuries or even death during applications.
●The components of the gas circuit works under pressure. The service given by unqualified
persons may cause explosions and operators can be injured seriously.
OVERUSE CAN CAUSE OVERHEATING
●Allow cooling period; follow rated duty cycle.
●Reduce current or reduce duty cycle before starting to weld again.
●Do not block airflow to unit.
●Do not filter airflow to unit without the approval of manufacturer

ARC WELDING CAN CAUSE INTERFERENCE

●Electromagnetic energy arising during welding and cutting operations can interfere with
sensitive electronic equipment such as microprocessors, computers, and computer-driven
equipment such as robots.
●Be sure all equipment in the welding area is electromagnetically compatible.
●To reduce possible interference, keep weld cables as short as possible, close together, and
down low, such as on the floor.
●To avoid possible EMC damages, locate welding operation as far as possible (100 meters) from
any sensitive electronic equipment.
●Be sure this welding machine is installed and grounded according to this manual.