Power Cord Set Requirements - Compaq Deskpro Workstation AP240 Reference Manual

General
Requirements
C
appendix
P C
OWER ORD
The power cord set meets the requirements for use in the
country where you purchased your equipment. The voltage
selection switch allows you to select the appropriate line voltage
for your workstation.
Power cord sets for use in other countries must meet the
requirements of the country where you use the workstation. For
more information on power cord set requirements, contact your
authorized Compaq reseller or service provider.
The requirements listed below are applicable to all countries:
The length of the power cord must be at least 6.0 feet
(1.8 m) and a maximum of 12 feet (3.7 m).
The power cord set must be approved by an acceptable
accredited agency responsible for evaluation in the
country where the power cord will be used.
The power cord set must have a minimum current
capacity and nominal voltage rating of 10 A/125 volts
AC, or 10A/250 volts AC, as required by each country's
power system.
The appliance coupler must meet the mechanical
configuration of an EN60320/IEC 320 Standard Sheet
C13 Connector, for mating with the appliance outlet on
the workstation.
S R
ET EQUIREMENTS
Reference Guide C-1