Compaq Deskpro Workstation AP240 Reference Manual page 44

Computer Setup
Continued
Heading Option
Storage Diskette Drives
Removable Media
IDE Devices
IDE Drive Timing
IDE Options
IDE DPS Self-Test
Boot Order
2-10 Software
Description
Enables/disables and sets configuration of drive A
(preinstalled diskette drive) and drive B devices.
Enables/disables removable media booting and
removable media writing.
Note: After saving changes to Removable Media, the
workstation will restart. Turn the workstation off, then
on, manually.
Lists information about IDE devices connected to the
system. ATAPI devices (CD-ROM, DVD-ROM,
LS-120, tape) are listed as ATAPI devices.
Allows you to set hard drive to Ultra DMA (Ultra-
ATA), Enhanced DMA, or PIO mode operation.
Note: The configuration of your workstation
determines which selections appear under this
option.
Allows you to enable or disable IDE drive translation
and/or the secondary IDE controller.
Allows you to execute self-tests on an IDE hard drive
capable of performing the Drive Protection System
(DPS) self-tests.
Note: This selection will only appear when at least
one drive capable of performing the IDE DPS self-
tests is attached to the system.
Allows you to specify boot order of installed
peripheral devices (such as diskette drive, hard drive,
CD-ROM drive, or DVD-ROM drive).
Continued