Tach Programming; Smart Tachless Mode - Code Alarm PROFESSIONAL ca6554 Installation Manual

Security and remote start
Hide thumbs Also See for PROFESSIONAL ca6554:
Table of Contents

Advertisement

Tach Programming

The unit will not operate unless tach is programmed or tachless option is
turned ON. If an attempt is made to start the vehicle via the remote start without first
programming tach, the unit will flash the parking lights 7 times indicating tach has not
been learned and stored. If the tach rate is not properly programmed to the specific
vehicle, the unit may not realize that the vehicle is running in certain instances and
re-engage the starter motor.
The Remote Start unit will learn the tach rate of most vehicle's single coil, multiple coil
packs, or single injector. To learn tach:
1.
Turn the ignition key to the ON position.
2.
Press and release the valet/override button 3 times.
3.
Immediately turn the ignition key OFF.
4.
Press and hold the valet/override button, then start the vehicle using
the key.
5.
When the unit senses the tach signal, the parking lights will begin to
flash.
6.
Allow the vehicle to settle to a normal idle speed.
7.
Release the valet/program push-button switch. The parking lights will
turn on for 2 seconds and 1 long chip will indicate that the learned
tach signal is stored and the unit has exited tach learn mode.
NOTE: If the unit fails to learn tach rate due to an improper tach connection or a
poor tach source, the parking lights will not flash. To correct this situation, locate and
connect the PURPLE/WHITE wire to the proper tach signal, and then repeat the tach
learn routine.

Smart Tachless Mode

Smart Tachless Mode is available only if a tach signal has never been learned to the
system and when activated will automatically change the Tach Mode feature in option
programming to Tachless without the need to enter the feature programming mode.
1.
Activate the remote start. The parking lights should begin flashing 7
times indicating no tach signal has been learned.
2.
Within the 7 flash time period, press and hold the
3.
The system will chirp 1 time indicating the system is now in tachless
mode.
2014 Voxx Electronics Corporation. All rights reserved.
button.
25

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PROFESSIONAL ca6554 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Professional ca6551

Table of Contents