Remote Vehicle Control System CA-630 Owner's Manual Car Start, Security and Convenience System IMPORTANT NOTE: The operation of the IV-F65 as described in this manual is applicable to most vehicles. However, due to the engine type and configuration of some vehicles (i.e.
Table of Contents Features and Benefits of the CODE ALARM CA-630 ... 3 Note: Any feature or function noted with “optional” requires additional installation labor, components and installation cost. See your dealer for details. Using the Security features ... 4/5...
The bright-blue warning light is an effective visual deterrent to a would-be thief. Remote Start The Code Alarm CA-630 allows you to warm up your vehicle and preheat or pre-cool the interior with the press of a button on the remote control.
Using the Security and Keyless Entry features LOCK Button Press to Arm Security System and Lock Doors FIND/PANIC Button Press for Car Finder Press and Hold for Panic Alarm Arming the Security System To arm the system, exit the vehicle, close all doors, then press* the LOCK button.
Using the Security and Keyless Entry features Activating Trunk Release Feature (vehicle must have power trunk/hatch) Press and hold the UNLOCK button for 2 seconds to open the vehicle trunk or hatch. Using the Progressive Car Finder Feature Press the FIND/PANIC button on the remote control to locate your vehicle.
If your vehicle stalls or does not start... If the vehicle stalls or does not start, the CA-630 will pause 5 seconds, then try 3 more times to start the vehicle (a total of four attempts). The system pauses 5 seconds between each start attempt. If the vehicle does not start after the fourth attempt, the CA-630 will abort the start process.
Pre-Heating or Pre-Cooling the Interior of the Vehicle Before exiting the vehicle, set the temperature controls to the desired setting and operation. After the CA-630 starts the vehicle, the heater or air-conditioning will activate and heat or cool the interior to your setting.
When removing the key from the ignition, the doors will automatically unlock. When Your Security System is Triggered The CA-630 will trigger if one of the following events occurs while the system is armed: • Any protected entrance is opened •...
It is not necessary to re-program the remote transmitter after changing the battery. Adding Remote Controls to Your System The CA-630 has the ability to operate from up to eight (8) remote controls. Follow these instructions to add a remote control to your system.
System Maintenance Deleting Lost or Stolen Remote Controls from Your System If one of your remote controls is lost or stolen, follow these instructions IMMEDIATELY to remove the control code from your system. 1. Have all remaining remote controls available. 2.
Emergency Disarm Procedure If your remote control is lost or fails to function, use this procedure to disarm the CA-630 and start your vehicle. 1. Use the keys to enter the vehicle. The alarm will sound once the door is opened.
Code Systems, Inc. Limited Lifetime Warranty Code Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehicle security product (the “Product”), purchased from an authorized CODE dealer, that (except as provided below) should this Product under normal use and conditions, be proven defective in material or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGINALLY INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without charge for parts directly related to repairs of the defect(s).
BILE OR HOMEOWNERS INSURANCE POLICY. THIS THEFT PRO- TECTION PROGRAM DOES NOT COVER LOSSES ARISING FROM THE THEFT OF ITEMS WITHIN THE AUTOMOBILE OR ANY DAM- AGES ARISING FROM, RELEATED TO, AND/OR INCIDENTAL OR A CONSEQUENCE OF A VEHICLE THEFT EXCEPT AS SPECIFICALLY DELINEATED BELOW.
Need help?
Do you have a question about the CA-630 and is the answer not in the manual?
Questions and answers