Registering A User Using Data Administrator - Olivetti d-Color MF220 Copy Operations

10
5
Press [Edit].
6
Place your finger on the authentication unit to scan the finger vein pattern.
% Scan the finger vein pattern three times; reset the same finger each time and then press [Scan] for
each scanning.
% After scanning the finger vein patterns, place the same finger on the authentication unit, and press
[Authentication Test].
% If your finger vein patterns have been authenticated in the authentication test, press [New]. If au-
thentication has failed, retry scanning the finger.
7
Press [Close] twice.
8
Enter the user name and password.
9
Configure function permission settings as required.
10
Press [OK].
11
Press [Close].

Registering a user using Data Administrator

To use Data Administrator, configure this machine, and set up Data Administrator. For setup, install the Bi-
oDriver (USB-Driver) of the authentication unit, and then install Data Administrator Bio Plugin.
NOTICE
Before setup, install Data Administrator V4.0 or later in your computer. For the Data Administrator operat-
ing environment and installation procedure, refer to the Data Administrator User's Guide.
10-8
Using an authentication unit (biometric type)
d-Color MF360/280/220 (Version 3)
10.1