Olivetti d-Color MF220 Copy Operations page 232

9
Message
[Replenish paper.]
[Toner (Y) is low. Replace when
indicated.]
[Replace toner cartridge (Y).]
[Toner is depleted. Replace the
toner cartridge following the
guidance (explanation). Press
the [Continue] button to contin-
ue the operations.]
[No more staples. Replace the
staple cartridge, or cancel sta-
pling.]
[Misfeed detected. Remove pa-
per according to the instruc-
tions.]
[Empty the hole-punch scrap
box. To continue the job, cancel
punching.]
[Reset the following number of
originals.]
[An internal error occurred.
Open and then close the front
door to remedy a problem. If the
trouble code appears again,
contact your Service Rep.]
[An internal error occurred. Turn
the main switch OFF and ON. If
the trouble code appears again,
contact your Service Rep.]
[Malfunction detected. Please
call your Service Representa-
tive.]
[Clean the original glass on the
left with the glass cleaner. Con-
tinuing using the machine in this
condition may cause lines to ap-
pear in the output.]
[Now Downloading Program
Data from the Firmware server.]
[Authentication information en-
tered is invalid, due to failed ac-
cess attempts. Contact your
administrator.]
[Due to failed access attempts,
the current administrator pass-
word is invalid.]
9-10
Cause
The indicated tray has run out of
paper.
The toner for the indicated color
is about to run out.
The toner is about to run out.
Toner is depleted.
The staples have run out.
Since a paper jam occurred, the
machine is unable to make cop-
ies.
(1) The hole-punch scrap box is
full.
(2)The Punch Scrap Box is not
installed.
After clearing a paper jam, it is
necessary to reload certain pag-
es of the original that have al-
ready been fed through the ADF.
The machine malfunctioned and
is unable to make copies.
The machine malfunctioned and
is unable to make copies.
The Slit Scan Glass is dirty.
(1) CS Remote Care was acti-
vated by your service represent-
ative.
(2) Internet ISW is being down-
loaded.
The authentication information
has become invalid since the au-
thentication attempts have failed
the specified number of times.
The administrator password has
become invalid since the authen-
tication attempts have failed the
specified number of times.
Troubleshooting table
Remedy
Add paper. (p. 8-4)
Prepare a spare Toner Car-
tridge for replacement following
the guidance contained in your
maintenance agreement.
Replace the Toner Cartridge
following the guidance contained
in your maintenance agreement.
Replace the Toner Cartridge
following the guidance contained
in your maintenance agreement.
Replace the Staple Cartridge.
Clear the jammed paper.
Throw punch scraps away from
the Punch Scrap Box.
Install the Punch Scrap Box.
Load the indicated original pages
into the ADF.
Take a remedy according to the
message displayed in the
screen. If the problem is not re-
solved or released, inform your
service representative of the
malfunction code displayed in
the screen.
Inform your service representa-
tive of the code displayed in the
screen.
Use the Slit Glass Cleaner to
clean it.
Do not turn off the Sub Power
Switch while this message is
displayed.
After turning off the Sub Power
Switch, turn off the Main Power
Switch, and then contact your
service representative.
Contact the administrator of the
machine.
Turn the machine off, then on
again.
Turn off the Main Power Switch,
and then wait at least 10 sec-
onds before turning it on again.
d-Color MF360/280/220 (Version 3)
9.2