3-Door Control (If External Reader And Exit Button Are Connected To Door1); 4-Door Control - IDTECK iTDC User Manual

8.3

3-Door Control (If external reader and exit button are connected to door1)

Instead of internal reader, exit button can be connected to door 1. Expansion I/O board
(EIO88) is required to connect exit button.
Door 1
Door 2
Door 3
8.4

4-Door Control

Expansion I/O board (EIO88) has to be equipped to control 4 doors.
Door 1
Door 2
Door 3
Door 4
RF reader can use external power but GND of external power and GND of
iTDC/iTDC-SR has to be grounded as common ground in this case, otherwise
communication error and system troubles are caused by noise from outside then
device's life is shortened.
PRODUCT INSTALLATION
External Reader
(Reader#1)
Exit Button
External Reader
(Reader#3)
Exit Button
External Reader
(Reader#4)
Exit Button
External Reader
(Reader#1)
Exit Button
External Reader
(Reader#2)
Exit Button
External Reader
(Reader#3)
Exit Button
External Reader
(Reader#4)
Exit Button
Connect to READER#1 port of iTDC/iTDC-SR main
board.
Connect to INPUT#1 port of iTDC/iTDC-SR main board.
Connect to READER#3 port of iTDC/iTDC-SR main
board.
Connect to INPUT#1 port of EIO88
Connect to READER#4 port of iTDC/iTDC-SR main
board.
Connect to INPUT#3 port of EIO88
Connect to READER#1 port to iTDC/iTDC-SR main
board.
Connect to INPUT#1 port of iTDC/iTDC-SR main board.
Connect to READER#2 port of iTDC/iTDC-SR main
board.
Connect to INPUT#3 port of iTDC/iTDC-SR main board.
Connect to READER#3 port of iTDC/iTDC-SR main
board.
Connect to INPUT#1 port of EIO88.
Connect to INPUT#4 port of iTDC/iTDC-SR main board.
Connect INPUT#3 port of EIO88.
p.47
iTDC