GB
INSTALLATION ACCESSORY
Select the installation location
Don't install at the place where cover with heavy oil, vapor or sulfureted gas, otherwise,
this product would be deformed that would lead to system malfunction.
Preparation before installation
1. Please confirm that all the following parts you have been supply.
No.
Name
1
Wire controller
2
Installation and owner's manual
3
Screws
4
Wall plugs
5
Screws
6
Plastic screw bars
7
Battery
8
The connection cable
2. Prepare the following assemblies on the site.
No.
Name
1
Switch box
2
Wiring Tube (Insulating
Sleeve and Tightening
Screw)
WIRED CONTROLLER INSTALLATION PRECAUTION
1. This manual provides the wired controller installation method. Refer to the wiring
diagram in this installation manual to wire the wired controller with the indoor unit.
2. The wired controller works in a low voltage loop circuit. Do not connect directly
to 208/230V and 460V. Do not wire this kind of wire into a loop. Wiring clear-
ance between the configured tubes should range 11.81−19.69 inches (30−50 cm)
or above.
3. The shielded wire of the wired controller must be properly grounded.
4. Upon finish the wire controller connection, do not employed tramegger to detect
the insulation.
28 /
Qty.
Remarks
1
--------
1
--------
3
M4X20 (For Mounting on the Wall)
3
For Mounting on the Wall
2
M4X25 (For Mounting on switch box)
2
For fixing on switch box
1
1
(Optional)
Qty. (embe-
Specification
ded into wall)
(only for reference)
1
--------
1
--------
Remarks
--------
--------