Wiring Figure - Ariston CONTROLLO A FILO Manual

Wired control manual

Table of Contents

Available languages

3. Wiring figure

4-core shielding wire

• Connect the female joint of the wires group from the mainboard with the male joint

of the connective wires group. (See Fig. 3-3)

• Connect the other side of the connective wires group with the male joint of the

wires group leads from the wire controller. (See Fig. 3-3)

4. Wire controller upper part Remove

• Insert a flat screwdriver into the slots in the

lower part of the wire controller (2 places).

• Remove the upper part of the wire controller

(Fig. 3-4)

NOTE: The PCB is mounted in the upper part of the

wired controller. Be careful not to damage the board

with the screwdriver.

5. Fasten the wire controller back plate

• For surface mounting, fasten the back plate on the wall with the 3 screws (M4x20)

and plugs. (Fig. 3-5)

Screws (M4×20)

30 /

The connection

cable

Back plate

Mainboard

CN40

Fig. 3-3

Slots

Fig. 3-4

Fig. 3-5

Table of Contents