Placing Documents; Placing Documents On The Platen Glass; Placing Documents In The Feeder - Canon imageCLASS MF5950dw Basic Operation Manual

Placing Documents

This section describes how to place documents on the platen
glass or in the feeder.

Placing Documents on the Platen Glass

1
Open the feeder.
2
Place your document face down.
3
Align the document with the appropriate paper
size marks.
If the document does not match any of the paper size marks, align
the center of your document with the arrow mark.
A4
B4
A5
A5
B4
A4
4
Close the feeder.
The machine is ready to scan or copy the document.
When scanning or copying is complete, remove the document
from the platen glass.
2-4
CAUTION
Precautions when closing the feeder
• Be careful not to get your fingers caught. This may
cause personal injury.
• Do not press down the feeder forcefully. This may
damage the platen glass and cause personal injury.

Placing Documents in the Feeder

1
Spread the document guides a little wider than
the document width.
2
Fan the document stack and align the edges of
the pages.
Thoroughly fan in
small batches
3
Neatly place the document face up.
• Place the document under the load limit guides (A).
• Make sure that the paper stack does not exceed the load limit
marks (B).
(A)
(B)
Align the edges on a
at surface a few times