Copying By Saving Paper - Canon imageCLASS MF5950dw Basic Operation Manual

Copying by Saving Paper

Press [ ] (Paper Save Copy) to save paper when making a
copy.
Choose one of the following four combinations of 2 on 1/4 on
1 and 2-Sided copy settings, as shown in the table below.
2 on 1 1->2-Sided
4 on 1 1->2-Sided
2 on 1 1->1-Sided
4 on 1 1->1-Sided
IMPORTANT
Precautions on 2-Sided Copying
• Do not touch your document when making 2-sided copying
until the process is complete. After copying on the front side is
complete, the document is partially output, reserved, and fed
into the machine again for copying on the back side.
• Be sure to close the paper switch cover before making 2-sided
copying.
Keys to be used for this operation
1
Set the paper switch lever correctly to fit the size
of paper used for 2-sided copying.
* If the lever is not set correctly, sheets may not be fed properly, or
paper jams may occur.
(1) Open the lower rear cover.
3-10
N on 1 2-Sided
Select Format Original
Layout Settings Orientation
1->2-Sided Portrait
1->2-Sided Portrait
OFF
OFF
Paper Save Copy
OK
(2) Set the blue-colored paper size switch lever (A) correctly.
• A4:
• Letter and legal: Push towards the far end
Original
Format
Book Type
Book Type
2
Place your document.
"Placing Documents" (→P. 2-4)
"Supported Document Types" (→P. 2-2)
3
Press [
4
Select the combination that you want to use
using [ ] or [ ] and press [OK].
Paper Save Copy
2 on 1 1 2-Sided
4 on 1 1 2-Sided
2 on 1 1 1-Sided
4 on 1 1 1-Sided
5
Select the document size using [ ] or [ ] and
press [OK].
Scan Size
Start
LTR
LGL
STMT
6
Press [
When the document is placed on the platen glass
(1) Place the next page and press [
* Repeat this step until all pages are scanned.
Scan Next: Press Start
<Start Copying>
<Cancel>
SheetxCopy:1x1/1
Density: 0
(2) Select <Start Copying> using [
Pull forward
(A)
(A)
] (Paper Save Copy).
] (Start).
] (Start).
+ -
] or [ ] and press [OK].