HOMCOM A90-030V01 Assembly & Instruction Manual page 15

Malfunctions
Unplug
Safety lock is not in the
Treadmill
right place
does
not work
Single wire or power
supply broken
Switch off
Not enough lubricating
Running belt dose
Not move
Running belt is too tight
smoothly
Control panel does not
E01 work
E02 Communication error
E04 Motor running error
Over current
E05
protection
Over voltage protection
E06
E07 Safety lock disconnected
Common malfunctions and solutions
Cause Solution
Connect the power cord
Put the emergency stop device on the right
place in control panel
Check signal wire
Switch on
Lubricate with silicone oil
Adjust the intensity of the running belt
Check whether the communicating wire is broken or
unplug
1. The main cable interface is loose;
2. The electronic watch is broken;
3. The controller is damaged;
1. Check if the motor line is inserted, please
re-insert the motor line
2. 2 to check if the motor is operating properly;
replacing the motor
3. check if there is a odor; replace the controller
Turn off the product and turn on again the product
will be ok.
Turn off the product and turn on again the product
will be ok.
1. The safety switch is not installed;
2. The induction wire of the safety switch is broken;
3. The safety switch interface of the electronic meter
is damaged;
-15-