Table of Contents
Advertisement
• If the cable is passed through a mast on a sailboat, be sure the cable does not
touch ropes (sheet, halyard, etc.).
• Do not let the cable touch the hull.
• The cable must be located where no tension is applied to the connectors. To
prevent tension, create a loop in the cable close to the sensor and tie the loop
with cable ties, as in the figure below.
• Wrap the junction of the connectors with self-vulcanizing tape for waterproofing.
1) Wrap the junction of the connectors
with one layer of self-vulcanizing
tape.
Self-vulcanizing tape
3) Wrap one layer of the vinyl tape over
the self-vulcanizing tape.
Vinyl tape
• Fasten the cable to the mast, etc. at the neck of each connector with a cable tie.
• Make loops with surplus cable.
5. Connect the cable assembly to the power source and display unit.
Loop cable and tie loop with cable ties.
2) Change wrap direction and wrap
one layer of the self-vulcanizing
tape again.
Self-vulcanizing tape
4) Change wrap direction and wrap one
layer of the vinyl tape again.
Vinyl tape
5
1. INSTALLATION
The minimum
bend diameter
is 242 mm.
Advertisement
Table of Contents
