Canon imagePROGRAF iPF6300S Basic Guide No.2 Basic Manual page 48

Error Messages
Error Message
Roll printing is selected, but
manual paper is loaded.
The roll is empty.
Cause
A print job for rolls was received
when a sheet is loaded.
The roll is empty.
There is remaining roll paper, but
because it could not be advanced,
it could not be detected.
48
Corrective Action
Follow these steps to load and print on a roll.
1. Press ▲ or ▼ to select Eject Paper , press the OK
button, and remove the sheet.
(→ , Removing Sheets)
2. Load a new roll.
(→ , Loading Rolls in the Printer)
The printer now starts printing the print job.
Press ▲ or ▼ to select Stop Printing , and then press
the OK button to stop printing.
Follow these steps to replace the used roll with a new
roll of the same type and size.
1. Press the OK button and remove the roll.
(→ , Removing the Roll from the Printer)
(→"Removing Rolls from the Roll Holder," User's
Guide)
2. Load the new roll.
(→ , Loading Rolls on the Roll Holder)
(→ , Loading Rolls in the Printer)
3. If no barcode was printed on the roll, specify the
type of paper.
(→"Changing the Type of Paper," User's Guide)
4. When you have selected ManageRemainRoll >
On in the control panel menu and a barcode is not
printed on the roll, also specify the paper length.
(→"Specifying the Paper Length," User's Guide)
5. If Not finished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
The unused portion of the roll is heavy, and this is
placing a burden on the printer. It may be helpful
to change the printing mode, which will change the
paper feed timing.
Choose a higher level of Print Quality in the
Advanced Settings of the printer driver.
(→"Giving Priority to Particular Graphic Elements and
Colors for Printing," User's Guide)