Canon imagePROGRAF iPF6300S Basic Guide No.2 Basic Manual page 39

Error Message
Borderless printng not possible.
Before borderless printing,
move the blue platen switch.
Prepare for parts replacement.
Parts replacement time has
passed.
Move the blue platen switch
No.xx to the right. (xx represents
a number)
Blue platen switch is dirty.
No x printhead (x is L, R, or not
displayed)
Cause
The paper is loaded askew.
The blue Switch on the platen was
set to the side opposite ● when a
borderless print job was received.
It is almost time to replace
consumables for which service is
required.
It is past the recommended time
to replace consumables for which
service is required.
The printer has detected that the
blue Switch on the platen needed
in maintenance during printing is
set away from the ● mark.
The blue Switch on the platen is
dirty.
No Printhead is installed.
39
Corrective Action
Press ▲ or ▼ to select Change Paper and straighten
the paper so that the edges are between the ink
grooves for borderless printing.
Insert the roll firmly until it touches the flange of the
Roll Holder . For borderless printing on A1 (594 mm
or 23.4 in) or A2 (420 mm or 16.5 in) rolls, attach the
Spacer for Borderless Printing on the Roll Holder .
(→ , Loading Rolls on the Roll Holder)
Select None when you have set Detect Mismatch in
the Control Panel menu to Warning .
However, note that this error may affect the printing
quality.
Press ▲ or ▼ to select Print With Border , and
then press the OK button to continue printing. The
document will be printed with a border.
Press ▲ or ▼ and select Stop Printing or press the
Stop button to stop printing.
Before borderless printing, set the blue Switch on the
platen to the ● side.
(→"Setting the Blue Switch on the Platen," User's
Guide)
You can continue to use the printer for some time
until Parts replacement time has passed. will be
displayed.
Contact your Canon dealer for assistance.
Contact your Canon dealer for assistance.
Set blue Switch on the platen that is identified in the
message toward the ● side.
(→"Setting the Blue Switch on the Platen," User's
Guide)
Open the Top Cover and clean the blue Switch on
the platen.
(→ , If Paper is Soiled)
Install the Printhead L if " Printhead L " is displayed
and the Printhead R if " Printhead R " is displayed. If
neither left or right is indicated, install both Printhead
L and Printhead R .
(→ , Replacing the Printhead)
Error Messages