Canon imagePROGRAF iPF6300S Basic Guide No.2 Basic Manual page 35

Error Message
End of paper feed.
Calibration There is a problem
with the multi-sensor.
Excessive temperature or
humidity.
Cannot calibrate.
Please execute calibration.
Insufficient paper for job
Cannot execute this command.
Use other paper.
Cause
You are pressing the ▲ button on
the Control Panel and trying to
rewind the roll to the edge.
The performance of a sensor
inside the printer may be impaired.
The temperature or humidity where
the printer is installed is out of the
acceptable range for operation.
The paper for printing a test
pattern is soiled. Otherwise, you
have loaded colored paper.
The test pattern was printed too
faintly.
Direct sunlight or strong lighting
may be shining on the printer and
causing the sensor to malfunction.
There is not even one color
calibration execution result.
This is displayed when paper is
loaded in the printer and Prompt
Execution is set to On on the
Control Panel menu.
The printer has received
a print job longer than the
amount of roll paper left when
ManageRemainRoll in the
Control Panel menu is On .
Paper compatible with color
calibration is not loaded.
35
Corrective Action
Release the ▲ button.
Press the OK button and cancel calibration. Contact
your Canon dealer for assistance.
Press ▲ or ▼ to select Stop , and then press the OK
button to stop printing.
Use the printer under suitable environmental
conditions. Also note that various environmental
conditions are recommended for various types of
paper. For details on the recommended environmental
conditions, see the Paper Reference Guide .
(→"Types of Paper," User's Guide)
Press ▲ or ▼ to select Continue , and then press the
OK button to continue with color calibration. However,
note that correct adjustment may not be possible.
Press the OK button to clear the error.
Load unused paper compatible with color calibration.
(→"Types of Paper," User's Guide)
Press the OK button to clear the error.
Take steps to remedy faint printing.
(→ , Troubleshooting)
Press the OK button to clear the error.
Take steps to ensure the printer is not used when
exposed to direct sunlight or strong lighting.
Execute color calibration.
(→"Using Color Calibration for Color Adjustment,"
User's Guide)
Set Prompt Execution to Off on the Control Panel
menu.
(→ , Menu Map)
Press ▲ or ▼ to select Print , and then press the OK
button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of the
document.
Press ▲ or ▼ to select Change Paper , and then
press the OK button.
Change the Paper Source of the printer driver, or
replace the roll with a roll that has enough paper for
the print job, and then print.
(→ , Removing the Roll from the Printer)
(→ , Loading Rolls in the Printer)
Press ▲ or ▼ and select Stop Printing or press the
Stop button to stop printing.
1. Press the OK button to clear the error.
2. Load paper that is compatible with color calibration.
See the Paper Reference Guide .
(→"Types of Paper," User's Guide)
Always make sure the loaded paper matches the
type of paper in the printer paper settings. Adjustment
cannot be completed correctly unless the loaded
paper matches the settings.
Error Messages