Page 1
Electronic Control Quick Start Guide • • Version 2.1...
Page 2
Control Board Diagram VIOLET: Antenna I/O YELLOW Function Indicator LEDs S: General Activity Indicator D: Board On-Board Diagnostics LEDs Wind: Activity Indicator • ON = Sensor has been triggered. • FLASHING = Sensor is waiting 15 minutes post-trigger, as preset by the manufacturer.
Page 3
Programming NOTE: It is always easier to program motors before they are attached to the frame. NOTE: Pick one remote to program and use as a master. Program everything to this one first. NOTE: To simplify, only connect power to the board you are programming. Press &...
Page 4
Miscellaneous Programming Programming an “All” Zone 1. Select one of the desired zones on the remote. 2. On the back of the remote, press and hold the Programming button until the motor jogs. 3. Select the zone one the remote that you want to designate as the “All” zone (Zone 5). 4.
Page 5
Rain Sensor Programming NOTE: The sensor will need to sit in the sun and charge before programming. 1. Select the zone on the remote that you want to program the sensor to. This will 2. Press and hold the “PROG” button on the back of the remote until the motors jog. 3.
Need help?
Do you have a question about the STRUXURE OUTDOOR and is the answer not in the manual?
Questions and answers
Control panel not opening/closing reliably. Red dot when up/down arrow pressed.