Vantrue Element 2 User Manual page 24

EN -Audio Recording: The default is ON. Set recording to on or off.
-Exposure: The default value is +0.0. Adjust the exposure of the lens.
-REC Status Light: Default setting is ON. You can choose to turn on/off the
recording status light.
-WDR: Default is on. WDR enables the camera to provide near-perfect
exposure under different lighting conditions. You can choose to turn
WDR on/off.
-Rotate Display: Default is off. You can choose to flip the video screen up
and down(180 degrees).
-Rear Mirror: The default is On. After it is turned on, the rear camera
image is displayed in mirror mode.
-Number Plate: Select the number or letter to be set. After setting, your
license plate number can be displayed in the recorded video.
-Stamp: Enable or disable the watermark stamp on video and photos.
The watermark stamp includes time and date label, VANTRUE label,
license plate number, GPS location information, and speed label. All
enabled by default.
-Time Lapse: The default value is disabled. You can choose to enable
1FPS/5FPS/10FPS/15FPS.
-Low-light Night Vision in Parking Mode: Default is on. When turned on, it
can optimize the recording effect of videos in parking mode.
-Parking Mode: You can choose the parking mode you need, including
Collision Detection/Motion Detection/Low Bitrate Recording/Low
Framerate Mode/OFF.
-GPS Settings: GPS is enabled by default. GPS ON/OFF settings, speed
unit settings, and GPS information are all set here.
B. System Setup
-Language: Available languages are Engish/Français/Español/Deutsch/I-
taliano/简体中文/русский/日本語/Polski.
-WiFi: The default setting is Off. After WiFi is enabled, mobile phones can
- 19 -