Line-Crossing - EverFocus H265 Series User Manual

3.5.1.4

Line-Crossing

When objects (human, vehicle or pedestrian & vehicle) cross a pre-defined line, the Line Crossing
Detection event will be triggered. You can configure some event actions like event recording, Email
alert or pop-up full screen when an event is triggered.
[ Line-Crossing Settings ] : You can configure the Line-Crossing setting here.
Enable: Enable or disable this function.
Sensitive: Sensitive level, range is 1-4, default to 2. If the detected object sensitivity is higher, the
moving Object can be detected easily. Meanwhile, the false detection rate is higher.
Dynamic Marking: Can choose to show or not show the track.
Detection Type: The detection types include pedestrian and vehicle. When the settings are enabled,
the only detect the alarms triggered by human or vehicles, but need to consume more CPU of IPC. If
it is not turned on, all objects passing through the line will be detected.
Rule Number: Max set 4 rule number. Draw a rule area on the area map, and click to the next few
rules, then you can draw rules on the area map. The rule switch and rule type of each rule are
independent, and they need to be opened, closed or set separately.
Rule Switch: The switch to every rule.
Rule Type: Setup to each rule, A->B means can detect A to B direction moving, B->A means can
detect B to A direction moving, A ←→B means can detect two directions moving.
Click Refresh to refresh the page; click Save to save the settings.
Value IPCam-SG Series – H265, 2MP / 5MP / 8MP
30