Canon CanoScan FB 1200S Getting Started page 17

Confirming the Status of the SCSI Card with Windows NT 4.0
After you have installed the SCSI card and driver, use the
procedures below to ensure that they are operating correctly.
1 Turn on the computer.
2 Click the Windows [Start] button on the taskbar and
select [Settings] and [Control Panel].
• The Control Panel will display.
3 Double-click the [SCSI Adapter] icon.
• The SCSI card is operating correctly if [aic78xx] displays in the
SCSI Adapter window.
4 Click
5 Turn off the computer.
WARNING
• If "aic78xx" does not display in the SCSI Adapter window,
install the SCSI driver with the following procedures.
1 Double-click the [SCSI Adapter] icon in the Control Panel.
2 Click the [Driver] tab.
3 Click the [Add] button.
4 Click the [Use Disk] button.
5 Place the supplied CanoScan Setup Utility CD-ROM in
6 Select the folder containing the SCSI driver and follow
• If the above procedures are followed to install the SCSI
driver, "Adaptec AVA-290XE PCI SCSI Controller (NT 4.0)"
should display in the SCSI Adapter window.
This concludes the procedures for installing the SCSI driver.
Proceed now to Connecting to the Computer.
at the top right of each window to close it.
the drive.
the instructions in the window to install it.
FB1200S Getting Started
Windows
Macintosh
15