Canon CanoScan FB 1200S Getting Started page 14

3 Click the [Device Manager] tab and click the [+]
mark beside the SCSI Controller item.
• The SCSI card is operating correctly if "Adaptec AIC-7850 PCI SCSI
Controller" displays underneath the SCSI Controller item.
4 Click
it.
• Windows NT 4.0
After you finish the next section, Installing the SCSI Driver, confirm that
the SCSI card is operating correctly. For instructions, read Confirming
the Status of the SCSI Card with Windows NT 4.0 (p. 15).
WARNING
• If the Adaptec AIC-7850 PCI SCSI Controller does not display in
the Device Manager tab, check the SCSI card installation. In
particular, check that the SCSI card is inserted all of the way
into the PCI bus slot (p. 9).
• If there are other cards than the SCSI card installed (sound
and network cards, etc.), there may be a conflict with the IRQ
and I/O port address that prevents the SCSI card or the other
card from working properly. If this should occur, change the
IRQ or I/O port address.
12
FB1200S Getting Started
at the top right of each window to close
Windows
Macintosh