Connecting To Wired Lan; Connect The Lan Cable - Canon Color imageCLASS MF8380Cdw Starter Manual

1 2
Preface Installing the Machine

Connecting to Wired LAN

Before adding the machine to a wired LAN
The computer and router/hub need to be connected using LAN
cables and the network settings need to be complete.
•
For more information, see the instruction manual for the network device you are
using, or contact the networking device manufacturer.
•
If the network has not been set up properly, you will not be able to use the machine
on the wired LAN network even if you perform the procedure described below.
Precautions when connecting to a wired LAN
•
The configuration of your computer or networked device, as well as the router functions, setting methods and security settings, vary depending on your
environment.
•
You can connect the machine to either a wireless LAN or wired LAN, but you cannot use both at the same time.
•
If using the machine in your office, consult with your network administrator.
1.

Connect the LAN cable.

2.
The machine sets the IP address automatically. Wait approximately
two minutes.
If you want to set the IP address manually, see the following.
e-Manual "Setting the IPv4 Address"
e-Manual "Setting the IPv6 Address"
For Windows
•
Installing via Network Connection P. 22
3
Configuring and Connecting the Fax
Connect the cable. Make sure that the
green indicator of
the LAN port is on.
Installing via Network Connection
4
Connecting to a Computer and
Installing the Drivers
Router
or
Internet
hub
About the LAN cable
•
The machine does not come with a LAN cable, router,
or hub. Have them ready as needed.
•
Use a Category 5 or higher twisted pair cable for the
LAN.
If the indicator is not on
Check the following.
•
Whether the machine and router/hub are
connected using a LAN cable
•
Whether the power of the machine is turned
ON
For Macintosh
•
Installing the Software P. 27
Appendix
LAN cable
21