- CX-ED1259L is the only ½” thick UL Fire listed RIM strike on considerations and a different installation technique. In addition, the market. This means that spacer plates (supplied with the Camden’s CX-ED1259L RIM strike is unique from competitive...
Page 3
CX-ED1259L ‘RIM’ Electric Strike INSTAL L AT ION INS T RUCT IONS Note: 1. Open door slightly, and remove the template. Jamb Hole punch Holes for self- tapping screws Hole punch Ø Jamb Connecting wire hole Note: 1. Use a Hole punch on marked positions 2.
Page 4
CX-ED1259L ‘RIM’ Electric Strike INSTA L L AT I O N I NST RU CTI ONS Step 2: Aligning the Strike 4. While adjusting strike, allow a small gap between strike 1. Using center line, measure 4 3/16” top and bottom, and body and crash bar (approx.
Page 5
CX-ED1259L ‘RIM’ Electric Strike INSTAL L AT ION INS T RUCT IONS Top View Jamb Latch Allow a small gap between strike body and crash bar. (Approx. Closed Door Crash Bar Spacer (install as needed) 10-32 x 1 (2pcs) 1/4-20 x 1...
Page 6
CX-ED1259L ‘RIM’ Electric Strike INSTA L L AT I O N I NST RU CTI ONS Step 3: Wiring the Strike Door Status Sensor White = N/O Orange = COM (Closed position) Grey = N/C FOR CUT WIRES GREY WHITE...
Step 2 – Confirm Door Alignment latch (as shown here) If the exit device has a deadlocking Virtually all of Camden’s electric strike models, including the latch, the CX-ED1259L RIM strike CX-ED1259L RIM strike, offer horizontal adjustment, to must be mounted so that the...
Page 8
CX-ED1259L ‘RIM’ Electric Strike INSTAL L AT ION INS T RUCT IONS Summary Consideration of the free movement of the exit device Adherence with the recommendations of this guide will avoid the latch and the keeper (jaws) most common problems associated with the installation of RIM of the RIM strike.