FPI I2450M Manual page 180

Client: FPI
Model: I2450
Pre-Test Notes
Pre-Test Start Time:
Air Control Setting:
Time
0:00 Started PB with 1.8 lb, torch for 20 sec
2:40 Closed door (1.1 lb)
5:00 Loaded 2.5 lb of kindling & startup (@ 0.5 lb)
19:00 Loaded remaining 2.4 lb of startup (@ 0.9 lb)
24:00 Leveled coal bed (2.2 lb)
25:00 Loaded high burn fuel
98:00 Leveled coal bed (6.2 lb)
132:00 End PB
Test Notes
Test Burn Start Time:
Air Control Setting:
Time
1:00 Fuel loaded, door closed
8:00 Air set halfway to test setting
11:00 Air set
17:00 Changed filter A
18:00 Changed filter B
30:00 Fan on
60:00 Changed filter A
68:00 Changed filter B
400:00 Stirred coals – 20 sec – see photos
Test Burn End Time:
Calibration Gas Values:
Calibration Results:
Zero
Time 10:07
CO 0.00
2
CO 0.000
Flue Gas Probe Leak Check:
Technician Signature:
ASTM E3053 Wood Heater Run Sheets
Job Number: 19-469
Run Number: 2
Wood Heater Run Notes
09:30
Fully Open
11:27
Open to med marking
19:18
Flue Gas Concentration Measurement
Span Gas
Mid Gas
Pre Test
Mid
10:12
10.00
2.484
Initial: No Leakage
Notes
Notes
CO (%): 16.93 CO (%): 4.33
2
CO (%): 10.00 CO (%): 2.51
2
Span Zero
10:10 19:27
16.93 0.01
4.330 0.013
Final: No Leakage
Date:
Tracking #: 0025
Test Date: 4/9/2019
Post Test
Mid
Span
19:30 19:31
9.84 16.74
2.419 4.117
4/19/2019
Page 1 of 3