Electrical Requirements; Mains Connection; Mains Cable; Scope Of Supply - AL-KO LSV 550/6 Manual

Product Description
Symbol Meaning
Lifting point for crane hook
2.6

Electrical requirements

2.6.1

Mains connection

DANGER! Risk of electric shock if the log
splitter is operated without residual current
circuit breaker. Operation of the appliance with-
out residual current circuit breaker in the mains
connection can result in serious injuries or even
death due to electric shock.
■
Before connecting the appliance, check
whether the mains connection has a residual
current circuit breaker for a maximum leak-
age current of 0.03 A.
■
If you cannot be sure that a residual current
circuit breaker is installed: Use an additional
portable residual current device with switched
PE conductor.
■
AC 230 V / 50 Hz
■
Minimum fusing of the mains connection =
16 A
2.6.2

Mains cable

WARNING! Risk of injury from electric
shock. A defective mains cable can result in seri-
ous injuries due to electric shock.
■
Ensure that the mains cable is not damaged
or severed.
■
Use only rubber-sheathed cables of quality
H07RN-F according to VDE 0282 Part 14
with a conductor cross section of at least
2.5 mm².
■
The maximum permissible cable length is
10 m. A longer cable impairs the motor power
and hence the performance and function of
the log splitter.
■
Mains cable, mains plug and coupling socket
must be undamaged. A defective mains ca-
ble (e.g. with cracks, cuts, crushed or kinked
points in the insulation) must not be used.
■
Repairs to the mains cable, mains plug and
coupling socket may only to be carried out by
qualified electricians.
442310_c
■
Do not expose plug connectors to moisture.
■
If the mains cable is damaged, immediately
disconnect it from the mains.
The mains cable must satisfy the following de-
mands:
For LSV 550/6:
■
Suitable for 230 V AC
■
3 cores (1P + N + PE)
■
Maximum cable length: 10 m
For LSV 560/8:
■
Suitable for 400 V AC
■
5 cores (3P + N + PE)
■
Maximum cable length: 10 m
2.7

Scope of supply

After unpacking, check that all the parts have
been delivered. Unpacking the appliance: see
chapter 4 "Unpacking appliance (05)", page 33.
2.7.1 Scope of supply for LSV 550/6 (03)
No. Component
1 Base unit
2 Operating arms (2x)
3 Retaining claws (2x)
4 Protective bracket (2x)
5 Wheels (2x)
6 Splitting table with lateral rests
7 Operating instructions
8 Bag with small parts
2.7.2 Scope of supply for LSV 560/8 (04)
No. Component
1 Base unit
2 Operating arms (2x)
3 Retaining claws (2x)
4 Protective bracket (2x)
5 Wheels (2x)
6 Splitting table with lateral rests
7 Operating instructions
8 Bag with small parts
31