Electro-Voice EVID S Series Installation Manual page 12

12 en | Installation and wiring
Wiring the speaker
To wire the speaker with two cables, do the following:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Tighten the gland nuts (C).
To wire the speaker with one cable, do the following:
1.
2.
3.
4.
5.
2022-03 | 07 | F.01U.345.358
Loosen both gland nuts.
Push the wire through the gland nuts.
Wire the Euroblock connector (A).
Adjust the tap settings, if needed.
Mount the speaker, as shown in the installation section.
A
Plug the Euroblock connector into the speaker.
Insert the four screws into the weather cover (B).
Loosely tighten the four screws to keep the weather cover in place.
Tighten all four screws to secure the weather cover.
Ensure the weather cover is secure.
Adjust the wire length.
Loosen both gland nuts.
Push the wire through one of the gland nuts.
Push the included plug in the other gland nut.
Tighten the gland nut with the plug to seal it.
Wire the Euroblock connector (A).
B
C
C
Installation Manual
EVID Surface Mount S Series - X Models
Electro-Voice