Makita DJV180 Instruction Manual page 8

ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing saw blade
CAUTION:
• Always clean out all chips or foreign matter
adhering to the blade and/or blade holder.
Failure to do so may cause insufficient tighten-
ing of the blade, resulting in a serious personal
injury.
• Do not touch the blade or the workpiece imme-
diately after operation; they may be extremely
hot and could burn your skin.
• Tighten the saw blade securely. Failure to do so
may cause a serious injury.
• When you remove the saw blade, be careful not
to hurt your fingers with the top of the blade or
the tips of workpiece.
To install the blade, open the tool opener to the position
shown in the figure.
1
► 1 . Tool opener
Keeping that situation, insert the saw blade into the
blade clamp as far as the two protrusions of the blade
can not be seen.
1
2
► 1 . Blade clamp 2. Jig saw blade 3. Protrusions
3
8 ENGLISH
Return the tool opener to its original position.
After installing, always make sure that the blade is
securely held in place by trying to pull it out.
CAUTION:
• Do not open the tool opener excessively, or it
may cause tool damage.
To remove the blade, open the tool opener to the posi-
tion shown in the figure. Pull the saw blade out toward
the base.
1
► 1 . Jig saw blade
NOTE:
• Occasionally lubricate the roller.
Hex wrench storage
1
► 1 . Base 2. Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
2